Servicing; General; Routine Maintenance; Cleaning - Vinten Vector 90 Instrucciones De Operación

General

The Vector 90 pan and tilt head is robustly made to high engineering standards and little attention is re-
quired to maintain serviceability save regular cleaning.
Refer to the appropriate section in the Maintenance Manual if any defect is apparent. Adjustments and re-
pairs should be carried out only by a competent person.

Routine maintenance

During use, check the following:
Check the illumination of the level bubble. Replace battery if necessary.
Check the effectiveness of the pan and tilt drag controls. Reset as necessary.
Check the effectiveness of the pan and tilt brakes. Reset as necessary.
No further routine maintenance is required.

Cleaning

During normal use the only cleaning required should be a regular wipe over with a lint-free cloth. Dirt ac-
cumulated during storage or periods of disuse may be removed with a semi-stiff brush. Particular attention
should be paid to the wedge location faces of the wedge adaptor.
NOTE: Use only detergent-based cleaners. DO NOT use solvent- or oil-based cleaners,
abrasives or wire brushes to remove accumulations of dirt as these damage the
protective surfaces
Use out-of-doors under adverse conditions may require special attention and the head should be covered
when not in use. Salt spray should be washed off using fresh water at the earliest opportunity. Sand and
dirt act as an abrasive and should be removed using a semi-stiff brush or a vacuum cleaner.

Level bubble battery replacement

(Fig 4)
The battery illuminates the level bubble (4) when the switch (12) is pressed. The level bubble remains lit
for approximately 15 seconds.
The battery should be replaced yearly or whenever the illumination is considered inadequate.
To replace the battery:
Prise out the battery cover (18).
Pull the battery (18.1) out of the battery compartment as far as the wiring will allow.
Pull the connector (18.2) off the terminals of the old battery and push it onto the terminals of the
new battery (18.1).
Install the battery (18.1) in the battery compartment, ensuring that the wiring is neatly stowed.
Refit the battery cover (18).
Press the illumination button (10) and ensure that the level bubble (9) is lit for approximately 15
seconds.

Servicing

English
15