Irritrol 500 Serie Guía De Instalación Y Operación página 15

• To set the start times for program A:
1. Press the START A key. The left side of the display will show a 1 then A
flashing repeatedly and 2:00 AM will show at the right. See example below.
Note: Once you have pressed the START A key, you must press the SET
TIME key within 15 seconds, otherwise, the START key must be pressed
again to make the changes.
2.
Press the SET TIME key. The hour digit and AM will begin to flash.
3. Press the or
4.
Press the SET TIME key again. The minute digits will begin to flash.
5.
Press the or
6.
To set additional start times, repeat steps 1 through 5 as required.
7. Press the CLOCK key when finished.
Note: On first power up, A and B programs star
the OFF position. Start time one is set to 2:00 AM for A and B programs.
• To set the start times for program B:
1. Press the START B key.
2. Repeat the previous procedure used for programming the start times in A
zones.
• To remove a program start time:
If a start time is not needed, set it to the OFF position as follows:
1. Select the appropriate program and start time by pressing the START A or
START B key until the desired start time number is displayed.
2. Press the SET TIME key until the hour flashes.
3. Press the or
Note: Off is displayed between 11:00 PM–12:00 AM.
4. Press the CLOCK key when finished.
PROGRAMMING STEPS
START NO. START
TIME
START NO. START
TIME
key until the appropriate hour is displayed.
key until appropriate minutes are displayed.
key until the word OFF is shown in the display.
15
AM
AM
t times numbers 2– 4 are set to