Operating Instructions; On/Off Cycling Of Compressor - Kobalt XC302000 Manual Del Usuario

OPERATING INSTRUCTIONS

START-UP / BREAK-IN PROCEDURE
WARNING
Risk of Personal Injury. Do not attach air
tools to open end of the hose until start-up is
completed and the unit checks okay.
1. Check oil level per the Lubrication Section (Pg 9)
of this manual.
2. Open the bottom tank drain valve (shown in Figure 9).
Turn outlet valve to open air flow.
3. Plug unit in.
4. Move pressure switch to the AUTO position to run the unit
(shown in Figure 10).
5. Run the unit for thirty (30) minutes at zero (0) psi (under
no load) to break in pump parts.
6. Move the pressure switch lever or knob to OFF and turn
tank drain valve to shut off air flow. The compressor is
now ready for use.
7. Change oil after first fifty (50) hours of operation. Then
perform oil changes every three (3) months or two
hundred (200) hours of run time, whichever comes first.
COMPRESSOR USE
It is extremely important to operate the compressor in a clean,
well-ventilated area where the surrounding air temperature will
not be more than 100°F. Do not locate the compressor air inlet
near steam, paint spray, sandblast areas or any other source of
contamination.

ON/OFF CYCLING OF COMPRESSOR

WARNING
Risk of Bursting. Drain tank every day to prevent corrosion
and possible injury due to tank damage. For optimal
performance of tank drain, tank pressure should be between
10 - 40 PSI. Do not operate drain with more than 40 PSI in
tank or drain valve may be damaged. Drain tank of moisture
daily using the drain valve in the bottom of the tank.
In the AUTO position, the compressor pumps air into the tank. When a shut-off (preset "cut-out") pressure
is reached, the compressor automatically shuts off.
If the compressor is left in the AUTO position and air is depleted from the tank by use of a tire chuck,
tool, etc., the compressor will restart automatically at its preset "cut-in" pressure. When a tool is being
used continuously, the compressor will cycle on and off automatically.
In the OFF position, the compressor will not operate.
WARNING
Risk of Personal Injury. Never disconnect
threaded joints with pressure in tank!
9
10
13