Manuales relacionados para Kyocera FAX System N
Resumen de contenidos para Kyocera FAX System N
- Página 1 INSTALLATION GUIDE FOR THE FACSIMILE SYSTEM GUIDE D’INSTALLATION DU SYSTEME FAX GUÍA DE INSTALACION PARA EL SISTEMA DE FACSIMIL INSTALLATIONSANLEITUNG FÜR DAS FAKSIMILE-SYSTEM GUIDA ALL’INSTALLAZIONE DEL SISTEMA FAX ファクスシステム設置手順書 FAX System (N)
-
Página 3: Supplied Parts
E JATE label (100V specification only) ..1 Option F FCC68 label (120V specification only)..1 H Memory module DIMM (32MB)....1 G Alphabet label Supplied parts (except 100 V specification) ....1 A Fax control assembly....... 1 B Harness ........... 1 C Modular cord (100V, 120V specification) .. -
Página 4: Installation Procedure
Installation Procedure Install the optional Memory module DIMM (32MB). Turn the MFP’s power switch to OFF and 1. Install memory module DIMM (H) in the memory slot at the center of the fax control assembly (A). Insert memory module DIMM (H) at an angle into the memory slot so that the notch (1) of memory unplug the MFP from the power supply before module DIMM (H) is positioned to the projection (2) of the memory slot. - Página 5 Remove the cover. Cut out the segments. 3. Remove thirteen screws (3) and then 4. Remove the screw (5) and then remove the modular cover (6). remove the rear cover (4). Push the projection (7) at the rear side of the modular cover (6) to remove the cover easily. 5.
- Página 6 Attach the Fax control assembly. 7. Connect the end of harness (B) that is covered by a white tube to the YC6 connector on the MFP’s main circuit board. 8. Pull the mains connector (8) out of the lower right of the MFP’s main circuit board. 9.
- Página 7 10. Secure the fax control assembly (A) with two M4 × 8-tap-tight S (D) screws. 11. Open the wire saddle (10). Connect the harness (B) to YC2 connector on the fax control assembly (A) and secure the harness by closing the wire sad- dle (10).
- Página 8 11(C) Install the cover. Connect the system to the telephone Attach the labels. (for 100V and 120V 13. Reinstall the rear cover (4) that has been line. specifications only) removed in Procedure 3 with thirteen screws 14. Insert the modular connector cable (11) into 15.
- Página 9 Attach the alphabet labels. (except for 100V specifications) [Operation check] 16. Wipe the area above the numeric keys at the right side of the operation panel and adhere the 1. Plug the MFP body into a power outlet, and turn on its main switch. alphabet labels (G) here.
- Página 10 MEMO...
- Página 11 MEMO...
- Página 12 2006. 7 303KK56711 Rev.2.0...