RIB K800 24V Manual Del Usuario página 33

ACCESSORIES -
E
XPANDER 24V CARD
!! FEED THE EXPANDER 24V CARD IN WHEN POWER IS NOT
SUPPLIED !!
- PEDESTRIAN OPENING COMMAND
- CLOSURE COMMAND AFTER PASSING THROUGH THE PHOTOCELLS
- 24Vac ACCESSORIES FEEDING
- STRIP CONTROL IN OPENING AND CLOSING
- CONNECTABLE TO TRAFFIC LIGHTS
- CONNECTABLE TO BOX LIGHT
C
ODE LEARNIG SYSTEM RADIORECEIVERS
RX433/A super eterodyne and coupling
RX433/A super eterodyne and terminal board
RX433/A 2CH super eterodyne, 2 channel and coupling code ACG5051
RX433/A 2CH super eterodyne, 2 channel and terminal board
R
ADIO TRANSMITTER SUN
SUN 2CH code ACG6052
SUN CLONE 2CH code ACG6056
S
ET SOLAR AMPLIFIER
Interface solar panels from 50 to 200W max. power.
For the connections and the technical data of the optional equipments follow the relevant
handbooks.
code ACG5471
code ACG5055
code ACG5056
code ACG5052
SUN 4CH code ACG6054
SUN CLONE 4CH code ACG6058
code AD00318
B
ATTERY
Battery 2,2Ah 12V
B
ATTERY CHARGE CARD
The 24Vdc 7 Ah battery recharge time (optional code ACG9510), at the first
installation is 24 hours, with 0,03 current supplied.
WARNING LIGHT FOR THE BATTERY STATE (COM-SIGN.)
In case of network voltage drop, with safety battery activation, this warning
light turns on, signalling the power mains failure, and starts blinking only
when the battery is charged. When the warning light blinks, all functions of
the control board are inhibited.
The warning light turns off only when the network is supplied with the due
voltage and all commands are ready to work again (the battery recharges
only when the network voltage is available).
NB: If you use too many warning lights, you risk to compromise the
logic of the control unit, possibly causing an operation block.
OPERATION WITH BLACK OUT
If a battery Is connected to the control board, the warning light indicating
the battery state turns on when the voltage is not enough, and signals that
the system is operating with the battery.
Gate operation is guaranteed up to a charge level of about 10V. Beyond
this level, the charge card gives a signal to the microprocessor that stops
the gate, making blink the warning light - gate open - and the warning light
- battery state -. Once the network voltage is available again, the recharge
card starts recharging the battery.
You just need to press the remote control (the opening button or the jogging
operation button) to open the gate.
When the gate Is open, operate a closing command or wait until the pause
time elapses and the gate automatically closes. The gate starts from the
closing position. When It Is closed, every normal function Is ready to be
activated again.
If no battery is connected to the control board, you do not need to follow
any particular procedure. When the network voltage Is available again, just
press the remote control, the opening button or the button for the jogging
operation, in order to open the gate. When the gate Is open, operate
a closing command or wait until the pause time elapses and the gate
automatically closes. The gate starts from the closing position.
When the gate is closed, every normal function is ready to be activated
again. Safety devices are ready to operate during the alignment phase.
33
33
G
B
code ACG9515
code ACG4662