Setting Of Additional Remote Controls; Remote Control Memory Clearing - FAAC TM2 ERX Manual De Instrucciones

SETTING OF ADDITIONAL REMOTE CONTROLS

Up to 15 remote controls can be set.
Tn: Already programmed remote control
Tx: Additional remote control
+
A B
Tn

REMOTE CONTROL MEMORY CLEARING

It is possible to delete singly all the memorized remote controls. When the last one
is deleted the motor initial condition is restored. The same applies to the single
channels of a multichannel remote control: just select the channel to cancel before
performing the sequence.
Tn: Remote control to be cleared
+
A B
Tn
TM2 ERX
B
Tn
A
Tn
35
B
Tx (2 sec)
B
Tn (2 sec)
A4518_6G41_Rev.A