Forced Remote Control Re-Programming With Furniture Function Active - FAAC TM2 ERX Manual De Instrucciones

FORCED REMOTE CONTROL RE-PROGRAMMING WITH FURNITURE
FUNCTION ACTIVE
If the remote control has been lost it's possible, by enabled "Furniture" function, to
memorize a new remote control.
To memorize a new remote control proceed as follows:
• Disconnect the power supply.
• Connect again the power supply.
From now it's possible during 1 minute to memorize a new remote control.
T1: New first remote control to be programmed
+
A B
B B
T1
T1 T1 (2 sec)
All previously programmed remote controls have been deleted.
TM2 ERX 41 A4518_6G41_Rev.A