Super-Sensitivity Obstacle Detection Management During Downwards Movements - FAAC TM2 ERX Manual De Instrucciones

SUPER-SENSITIVITY OBSTACLE DETECTION MANAGEMENT
Where required it is possible to activate/deactivate a high level of obstacle detection
sensitivity during downwards movement. This Super-sensitivity is automatically
disabled when the blinds slats begin to pile up.
ACTIVATING THE SUPER-SENSITIVITY FUNCTION
Tn: Already programmed remote control
+
B C
Tn
ACTIVATION OF THE "FURNITURE" FUNCTION
The "Furniture" function is meant for special applications in the moving blinds
sector. This should NOT be disabled in proximity to the lower limit switch position,
and may be used only if the super-sensitivity function has already been activated.
Tn: Already programmed remote control
+
B C
Tn
DEACTIVATING THE SUPER-SENSITIVITY FUNCTION
Tn: Already programmed remote control
+
B C
Tn
ATTENTION By deactivating the super-sensitivity function the
"Furniture" function will automatically be deactivated.
TM2 ERX
DURING DOWNWARDS MOVEMENTS
- only for Ø 35 motors
A
C
A
40
Tn
Tn
Tn
+
B C
Tn (2 sec)
+
B C
Tn (2 sec)
+
A B
Tn (2 sec)
A4518_6G41_Rev.A