Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
product. The surface must be
clean, free from grease and dry.
The adhesion of the double-sided
adhesive strip
5
wise be limited.
Note: Before use, check on a hid-
den area of the surface, whether
the adhesive can cause damage.
Peel the protective film off the
adhesive strip on the back of
the LED strip
the LED strip in the desired
location.
Secure the LED driver
the included double-sided
adhesive strip
cluded screws
Connect the power supply
with the LED driver.
Then connect the LED driver to
the LED strip.
Note: When connecting the
LED driver with the LED strip,
be sure to match up the
VGGD mark on the LED
driver and the VCC-GND-
GND-DI mark on the LED strip.
Be sure the power supply is
always accessible.
24 GB/IE
,
may other-
10
and secure
2
with
4
or the in-
5
.
8
3
Plug the power supply into
the socket before switching
the product on.
Connecting 2 LED
strips (see Fig. B)
Note: Up to two 5 m LED strips
may be connected using the
eight-pin plug
9
with the LED driver
power supply
3
there is a risk of overloading the
components and fire!
Note: When connecting the two
ends of the LED strip using an
eight-pin plug, be sure to match
up the VCC-GND-GND-D0 and
VCC-GND-GND-DI marks at the
ends of the LED strips.
After connecting the two LED
strips, only the first LED strip
is lighting once connected to
electricity supply.
To light up the second LED
strip, press the
then press the
switch groups of three lights
on, starting from the begin-
ning of the second LED strip.
and operated
and a
4
. Otherwise
button and
IC Set
button to
Publicidad
Capítulos
Tabla de contenido
