Scotsman SCE275 Indicaciones Para El Uso página 8

The machine is now exposed for service.
How to Operate the Controller
The controller is a microprocessor device that receives
input from several sources and switches various
components on and off.
Its manual control is through the use of the push button
switches.
Freeze Button: Pushing and releasing this button starts or
restarts the machine.
Harvest Button: Pushing and releasing this button will
cause the machine to go directly to a Harvest Cycle. Can
be done from either Freeze or Off. The machine will
switch off at the end of the Harvest Cycle.
Clean Button: Pushing and releasing this button will
cause the machine to go into a clean cycle. After the ice
machine cleaner has circulated for about 10 minutes, a
second push of this button will start the rinse period.
Off Button: Pushing and releasing this button will switch
the machine off a the end of the next cycle. If the button
is pushed and held for more than 3 seconds the unit will
switch off immediately.
To reset: First push and release the off button, then push
and release the freeze button.
Cleaning Schedule:
Scrub the door and frame edges once a week with soap
and water.
Sanitize the bin interior once a month.
Clean the water system and air cooled condenser a
minimum of twice per year. If in an area of high mineral
concentration in the water supply, clean water system 4
times a year.
This ice machine will perform at its best when kept
clean. There are three areas to keep clean: The water
system including the water reservoir, distributors and
evaporator surface; the bin controls; and the air cooled
condenser filter and the condenser itself.
Air Filter (air cooled only):
The air filter is located in a slot between the condenser
fins and the condenser fans.
1. Remove the grill on the left front of the unit.
2. Locate the filter edge, it is between the condenser fins
and the fan motors.
3. Pull the filter to the left though the slot in the front
base of the ice machine.
4. Wash the surface of the filter off with cold water, or,
if torn or so dirty it can't be cleaned, replace with a new
filter.
5. Return the filter to its installed position.
Grill Screws
Grill Removal
8