Replacement Parts - Shark GS300 Guia Del Usuario

MAINTENANCE
CLEANING & STORING
1 Turn the steamer off "0" and
unplug from the electrical outlet.
Let the steamer cool for 30
minutes and empty the water
from the water tank.
2 Hang the steam nozzle on the
cradle and secure using the safety
nozzle strap.
TROUBLESHOOTING GUIDE & REPLACEMENT PARTS
PROBLEM
There is no steam.
The nozzle leaves water drops
on the garment.
Unit wont turn on.

REPLACEMENT PARTS

A 100SDL
Bristle Brush Frame
B XPD300 Steam Bonnet
To order any of the above replacement parts, go to www.sharkclean.com or call 1-800-798-7398.
10 TOLL FREE: 1-800-798-7398
GS300_IB_ENG_SPA_101110.indd 10
3 Collapse the telescoping pole for
compact storage and loop the
power cord through the safety
nozzle strap.
4 Wipe the exterior of the steamer
with a damp cloth and wipe dry if
needed.
SUGGESTED SOLUTION
1 Make sure the unit is plugged in and turned on.
2 The water tank might be empty, add water.
3 The water cap is not fully pushed in, press the cap down and turn clockwise
to secure tightly.
4 The steam hose is not fully extended, use the steamer in an up and down
motion making sure the hose isn't too bent.
1 Make sure the steam bonnet is attached to the nozzle.
2 The steam bonnet could be too wet, remove the bonnet and let it dry
before reusing.
3 The steam hose is bent, straighten the hose to eliminate condensation
build up.
1 Make sure the unit is plugged in and turned into the "I" position.
5 Store the steamer in a cool
dry place.
6 "Periodically, remove the steam
hose from the steam unit and
turn the water tank upside down
over the sink to empty any excess
water. This will prolong the life of
the garment steamer."
10-11-11 9:58 AM