Filling The Water Tank; Important - Shark GS300 Guia Del Usuario

ASSEMBLY- cont.

FILLING THE WATER TANK

1 Make sure the unit is unplugged
before filling
2 Detach the steam hose from the
steam main unit by turning the
hose connector counterclockwise.
This should be done only when
the unit is cool. (fig. 5)
3 Remove the steam main unit from
the base. Pull the release button
on the front of the unit towards
you and lift the front of the steam
unit off the base to disconnect.
(fig. 6)
6 TOLL FREE: 1-800-798-7398
GS300_IB_ENG_SPA_101110.indd 6
fig. 5
fig. 6
4 Unscrew the water cap from
the inlet, the cap is tethered to
the water tank and can not be
completely removed. (fig. 7)
5 Fill the water tank under the
faucet to the max fill line.
6 Replace the cap on the filling
inlet. Push the cap down and turn
clockwise to lock.
7 Reattach the steam hose to the
steam unit.
IMPORTANT: The water tank
cap must be securely locked into
place or steam will not emit.
fig. 7
8 If filling during use, unplug the
unit from the power outlet and
using a cup, fill the water tank to
the max fill line.
WARNING: Do not fill the water
tank when the unit is plugged in to
an electrical outlet.
WARNING: The steam is hot! Be
careful not to touch the steam
nozzle when the unit is turned on
or has been in use.
10-11-11 9:58 AM