Fagor Trans'therm ARTT-20 Instrucciones Generales Para Instalación, Uso Y Mantenimiento página 15

Armario de regeneración Trans therm
You have 10 seconds to adjust the timer setting. After 10 seconds, the indicator and the
display no longer flash, and a flashing dot appears on the F display. The timer setting is
fixed and the countdown starts.
If you realise that you have made a mistake in adjusting the timer, stop the appliance and
You may now once again adjust the timer.
Using the probe option
The timer is not used.
D3, as well as E, flash.
Disp
If you no longer wish to work with the temperature probe, stop the appliance and start it
Setting the humidifier (optional).
settings.
position 1 corresponds to minimum humidity.
position 1 1 corresponds to maximum humidity.
Start up the appliance by pressing «1»
Preheat the appliance (approximately 10 minutes)
Adjust the humidification, if you have this option
Open the door and:
10, 18 or 20-level appliance: enter the pre-filled trolley.
5-level appliance:
For use without loading trolley: load the trays or containers into the compartment situated
inside the appliance.
or
For use with loading trolley: enter the pre-filled compartment with the loading trolley.
For use with the timer:
Close the door
Set the timer
After 10 seconds, the timer is set and the countdown begins
If you do not wish to use temperature hold mode, you may remove the trays and contai
ners.
If you wish to leave the products inside the cupboard while holding the temperature,
stabilize at the holding temperature. Use of the timer is not necessary. You may use it as an
alarm
-14-
USE