Festo CMMP Serie Manual Del Usuario página 30

Preparations for commissioning
1. Connect motors.
2. Connect CMMP-AS motor controller.
3. Connect the PC.
4. Check readiness to operate.
– Make sure that the controller enable switch is swit-
ched off.
– Switch on the power supplies for all devices. The
READY LEDs on the front of the device should now
light up.
5. Install the parametrising software on your PC.
– Enter the data storage device in the disc drive.
– If the SETUP program does not start automatically,
start the WINDOWS Explorer.
– Select the disk drive in which the parametrising soft-
ware is inserted.
– Start the program SETUP.EXE (double-click).
6. Follow the installation instructions for the parametrising
software.
30 Festo P.BE-K-CMMP-AS-C20 1010NH English