General Safety Precautions For The User - entrematic Ditec CROSS30 Manual De Instalación Y Mantenimiento

OPERATING INSTRUCTIONS FOR FOR SLIDING GATES AUTOMATION CROSS30
RELEASE INSTRUCTIONS
In case of fault or power failure, insert the key and turn it
clockwise. Open the removable cover and unlock the pinion
gear by turning the pinion gear pin counterclockwise by means
of the provided tool.
This allows to push the gate manually.
LOCK INSTRUCTION
To relock the geared motor, rotate the pinion clockwise, strongly
tighten, and re-close the door.
GENERAL SAFETY PRECAUTIONS
FOR THE USER
These precautions are an integral and essential part of the
product and must be supplied to the user.
Read them carefully since they contain important information on
safe installation, use and maintenance.
These instructions must be kept and forwarded to all possible
future users of the system.
it was designed.
Any other use is to be considered improper and therefore dan-
gerous. The manufacturer cannot be held responsible for any
damage caused by improper, incorrect or unreasonable use.
Avoid operating in the proximity of the hinges or moving mechani-
cal parts. Do not enter within the operating range of the motorised
door or gate while it is moving.
Do not obstruct the motion of the motorised door or gate, as this
may cause a dangerous situation.
The motorised door or gate may be used by children over the age
of 8 and by people with reduced physical, sensorial or mental
abilities, or lack of experience or knowledge, as long as they are
properly supervised or have been instructed in the safe use of
the device and the relative hazards.
Children must be supervised to make sure they do not play with
the device, nor play/remain in the sphere of action of the motor-
ised door or gate.
Keep remote controls and/or any other command devices out of
the reach of children, to avoid any accidental activation of the
motorised door or gate.
In the event of a product fault or malfunction, turn off the power
supply switch. Do not attempt to repair or intervene directly, and
Failure to comply with the above may cause a dangerous situ-
ation.
Any repairs or technical interventions must be carried out by
Cleaning and maintenance work must not be carried out by
children unless they are supervised.
manufacturer's indications must be complied with and only quali-
ised door or gate. In particular, regular checks are recommended
in order to verify that the safety devices are operating correctly.
All installation, maintenance and repair work must be documented
and made available to the user.
Only lock and release the door wings when the motor is switched
off. Do not enter within the operating range of the wing.
ON
OFF
Installer:
-
Entrematic Group AB
Lodjursgatan 10
SE-261 44, Landskrona
Sweden
www.entrematic.com