Installation Of The Face Plate Assembly - General - schmalenberger fluvo C2 rondo Instrucciones De Operación

4.11

Installation of the face plate assembly - general

fig. 21
4.11.1 Face plate assembly installation / Concrete-tile pool
fig. 22
56
8434
8435
Schmalenberger GmbH + Co. KG
D-72072 Tübingen / Germany
OPERATING INSTRUCTIONS
A Hose coupling
B Plug sleeve
21 Hose
35/35.1 Face plate assembly for
concrete pool
Drain the pool water, if already filled, to
below the installation kit. Firmly place the
hose (21) with the hose coupling (A) onto
the plug sleeve (B) on the face plate
assembly (35/35.1). With that the air
button is connected to the switchgear
cabinet.
C Mounting protection film
10 Suction housing
20 Installation kit
21 Switching tube
35 Face plate assembly
90.1 Screw
Remove the mounting protection film (C).
After connecting the air button, put on the
face plate assembly (35), this allows the
pressure connection and air connection
to slide into one another. Fasten to the
installation kit (20) with the screws (90.1).
Warning!
Make sure that there is not a kink in the
switching tube (21), lay it in a loop and do
not shorten!
C2 rondo
Version: 27200 - D