Shutdown / Overwintering; Empty The Pool - schmalenberger fluvo C2 rondo Instrucciones De Operación

OPERATING INSTRUCTIONS
Functional fault
1. Pump runs very loudly and lacks
performance
2. Pump starts up heavily and slowly A current phase is missing
3. The fuses jump out when the
pump is switched on
4. Motor protection switch trips
5. Centrifugal pump cannot be
switched on from the pool
6. Air valve leaks
8

Shutdown / Overwintering

Warning! Risk of damage!
If there is a risk of freezing, then the facility must be made winterproof. For this
observe the following recommendations:
8.1

Empty the pool

fig. 33
C2 rondo
Version: 27200 - D
Possible cause
Motor rotating in the wrong direction Re-pole the motor in the terminal box
Motor blower brushes against the
blower cover
Wrong or too nimble fuses
Wrong setting
- Switching tube has a kink in it
- Fuse / power supply
- Motor protection switch
- Switching tube too long
- Water in the switching tube
dirty
Warning! Risk of damage!
Make sure you have protected the whole
swimming complex adequately against
frost. Observe the instructions issued by
the manufacturer of the pool!
•
•
•
8325
Schmalenberger GmbH + Co. KG
D-72072 Tübingen / Germany
Remedy
and reverse the direction
Fasten the blower cover properly
Check supplies and fuses
Insert passive fuses with the correct
current rating.
Set correct current value +10% (see
Technical Data)
Check whether centrifugal pump can
be switched from the switchgear box.
- Eliminate causes in accordance
with chapter 4 .
Shorten switching tube, if possible.
- Blow through the switching tube
from the swimming pool end
Screw the air valve off and wash it
out during normal operation.
Replace it, if necessary.
Note: The air valve must be located
above the water surface.
Empty all the water out of the pool,
or let the water out at least until it is
below the level of the jet head.
Switch off the master switch!
63