Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Remove the wand from the gun.
2.
Clear the nozzle by forcing a stiff wire or straightened out paper clip (small size)
through the center hole of each nozzle.
3.
Backflush the nozzle with water from both ends.
4.
Reconnect the wand to the gun.
Restart the pressure washer and depress the trigger on the spray gun.
LUBRICATION
The pressure washer is designed with a permanent lubrication system. Conventional
oil checks and changes are not necessary.
NOTE: In case of oil leakage, contact our customer service department at
www.simpsoncleaning.com. A SMALL AMOUNT OF OIL LEAKAGE IS NORMAL.
WATER SCREEN FILTER
The pressure washer is equipped with a water inlet screen filter to protect the
pump. Never operate the pressure washer without the screen filter in place.
CAUTION: If the screen filter is not kept clean, the flow of water to the pressure
washer will be restricted and the pump may be damaged.
•
To clean the inlet water screen filter, remove garden hose connector (D) and
remove the screen filter from the inlet.
•
Flush screen filter with warm water to clean.
•
Replace screen filter, and garden hose connector immediately to prevent any
foreign matter from entering the pump.
CAUTION: Do not damage the screen filter, while removing or cleaning. Any
foreign particles entering the pump may damage the pump.
COOLING SYSTEM
The air vents, located in and around the pressure washer, must be kept clean and
free of any obstructions to ensure proper air cooling of the motor during operation.
WARNING: Prevent water from penetrating the vents of the pressure washer
to minimize the risk of damage to the machine and to reduce the risk of shock to
the operator.
CAUTION: Prior to moving the unit, always disconnect the garden hose via the
garden hose connector.
CAUTION: Always store your pressure washer in a location where the tem-
perature will not fall below 40 °F (4 °C). The pump in this machine is susceptible
to permanent damage if frozen. FREEZE DAMAGE IS NOT COVERED BY THE
WARRANTY.
END OF uSE AND WINTER STORAgE INSTRuCTIONS
1.
When finished using the pressure washer, you must first drain and rinse the
detergent tank.
2.
Run the pressure washer in low pressure until all of the soap is drained from
the detergent tank.
3.
Pour clear water into the tank and run it through on low pressure as though it
were detergent.
NOTICE: Failure to clean properly will cause bottle or suction tube to become
clogged and inoperable.
STORAGE
15 - ENG
Publicidad
Tabla de contenido
