Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATIONAL
ISSuE
No water
coming out
of nozzle
No water
coming out
of nozzle
Spray Gun
Trigger will
NOT Move
Unit will
NOT start
NOTE: Unit will
only start and
run when trigger
is depressed
and water is
spraying!
POSSIbLE
SOLUTION
CAuSE
Nozzle is
Clean the nozzle according to the instructions
provided in the Nozzle paragraph under
clogged
Maintenance section of this manual.
Water inlet
Remove the filter screen (O) from the
filter screen
water inlet (M) and clean it thoroughly.
is clogged
Replace the filter screen.
Kink in the
Use a maximum garden hose length of
garden hose
50 ft. (15.2 m) (city water) or 25 ft. (7.5 m)
or hose is
(well water). Ensure the garden hose is laid
wrapped on a
out flat and does not have any kinks or leaks.
storage wheel
Unwrap garden hose from reel or hook (if
applicable). Replace garden hose if necessary.
See How to use Spray Wand
Nozzle is
not installed
paragraph in the Operation Section.
correctly
Detergent
Remove the Gun and Hose assembly from
Suction
the front of the unit. Aim water stream away
Assembly
from electric source. Turn the faucet on. Water
(the part
should start to come out of the front of the unit.
which the
If no wa ter comes out, the Detergent Suction
High Pressure
Assembly will have to be cleaned or replaced.
Hose con-
Contact our customer service department at
nects to) is
www.simpsoncleaning.com.
malfunc-
tioning
Gun safety
Release safety lock according to instructions
provided in the Starting paragraph
lock is
engaged
under Operation in this manual.
Unit is not
Verify that the On/Off Switch (I) is
turned ON
fully engaged in the ON position.
GFCI Plug
Confirm the GFCI plug is reset and
is not reset
functioning according to instructions
provided in ground-Fault Circuit Interrupter
Protection paragraph under Power
Supply & Electrical info in this manual.
20- ENG
Publicidad
Tabla de contenido
