Simpson 13SIE-170 Manual De Instrucciones página 21

OPERATIONAL
ISSuE
Motor stops
working
during normal
operation
NOTE: Motor's
thermal
overload switch
is tripping
because
the motor is
overheated
Allow the motor
to cool for 20
minutes before
troubleshooting
and the
switch will
automatically
reset.
Connecting and
Disconnecting
the Spray Wand
NOTE: Due
to the high
pressures
produced by
your pressure
washer, the
wand must
seal tightly to
the gun. As the
result of normal
operation the
wand can
become difficult
to attach or
remove and
this process
may require
considerable
force.
POSSIbLE SOLUTION
CAuSE
Extension We do not recommend the use of extension
cord is too cords with your pressure washer. If you must
long or wire use an extension cord, verify that it meets
gauge is the minimum requirements listed in the
Extension Cord paragraph under the Power
too small
Supply & Electrical Info in this manual.
Nozzle is Clean the nozzle according to the instructions
clogged provided in the Nozzle paragraph under
Maintenance section of this manual.
Defective Turn unit OFF, disconnect incoming water
Spray Gun from unit, and remove the gun and hose
assembly. Aim pressure washer away from the
electrical outlet, reconnect incoming water,
and switch the unit into the ON position. If
the motor starts and water flows steadily
out of the front (and you have verified that
the nozzle is not clogged), the spray gun
may be malfunctioning and need to be
replaced. Please contact our customer service
department at www.simpsoncleaning.com.
To attach the Wand – apply steady downward
pressure on the wand (In the direction of the
trigger) while simultaneously twisting the wand
90°. It may help if you set the gun vertically on a
flat surface with the wand pointing upwards. The
two tabs on the end of the wand must be fully
inserted in the gun before the wand will twist
and lock. If this does not work then remove the
bayonet o-ring from the end of the wand and
attach the wand to the gun without the o-ring in
place. If the wand attaches to the gun without
the o-ring in place you will need to replace the
o-ring. Please contact our customer service
department at www.simpsoncleaning.com.
To remove the Wand – release any trapped
pressure in the gun / hose by turning the unit
OFF and squeezing the gun trigger. Apply steady
downward pressure on the wand (In the direction
of the trigger) while simultaneously twisting the
wand 90°. It may help if you set the gun vertically
on a flat surface with the wand pointing upwards.
21 - ENG