Festo DGCI Instrucciones De Utilizacion página 32

DGCI-...
Fastening the work load
S
Place the work load so that the tilting
torque of force F parallel to the movement
axis and the lever arm a remains low
( Technical Specifications: M
With hard and stiff work loads
Note
If the slide 3 becomes bent against a
buckled work load, the service life of
the guide will be reduced.
S Make sure that the mounting surface
for the work load is bent maximum
0.01 mm.
S
Note the tightening torques when fasten-
ing the work load on the slide:
DGCI-...
Tightening torque [Nm]
Fig. 12
Work loads with their own guide:
S
Adjust the guides of the work load and of the DGCI so that they are exactly
parallel.
Only in this way can you avoid overloading on the slide (permitted forces
Technical Specifications).
S
Make sure that the work load is coupled free of play to the DGCI (< 0.1 mm).
32
, M , M ).
x y z
Fig. 10
3
Fig. 11
18 25
M5 3.5 3.5
M6 – 6.5
M8 –
32 40 63
–
10
Festo DGCI-...-Z6 1207b English