Festo DGCI Instrucciones De Utilizacion página 37

DGCI-...
The diagrams in Fig. 18 have a centre of gravity
distance r of:
– 35 mm with DGCI-18
– 50 mm with DGCI-25 ... 63
Tip:
Use shock absorber supports KYC which can be shifted over the complete
stroke.
S
Check that the tubing is connected correctly.
S
Start a test run as described in the manuals for the controller.
S
Check that the settngs on the DGCI and all configuration data in the controllers
used (e.g. SPC200) are correct:
– fixed stops
– max. positioning range
– movement sequence
– no obstructions which limit movement.
When high demands are placed on the positioning behaviour of the SPC200.
S
Take into account a stroke reduction r for each end position. Only limited
positioning behaviour is available within the stroke reduction.
You will achieve the best possible position-
ing behaviour with a stroke reduction of
10 % per end position. However, the stroke
reduction must not drop below the follow-
ing values.
DGCI-...
Stroke reduction r
Fig. 21
When used with SPC11 (Soft Stop)
S
Make sure that the end stops are stable and cannot deform elastically.
Festo DGCI-...-Z6 1207b English
18
25
[mm] 20 25
Fig. 19
Fig. 20
32 40
25 35
63
35
37