Dismantling And Repairs - Festo DNCI Instrucciones De Utilizacion

DNCI
9

Dismantling and repairs

Dismantling
Warning
There is a danger of injury caused by pres
sure forces which can eject the sensor if
the connecting screws are loosened under
pressure.
S Make sure that the following sources of
energy are switched off:
the operating voltage
the compressed air (drive exhausted
on both sides).
The sensor projects into the pressure
chamber of the DNCI.
Replacing the sensor
1. Unscrew the fastening screws.
2. Replace the sensor.
Note here the mechanical coding on the sensor housing and make sure that the
seal is seated correctly.
3. Screw the fastening screws in again.
The tightening torque is 0.6 Nm.
Recommendation:
Return the product to our repair service for overhaul.
S
The necessary fine adjustments and tests will then be taken into account.
Information on spare parts and aids can be found under:
S
www.festo.com/spareparts
Festo DNCI 0907c English
Fig. 14
27