Operating The Unit - MTD H15 Instrucciones De Funcionamiento

Operating manual
Mix petrol and fill the tank

in a clean, well ventilated outdoor
area only where there are no
sparks or flames.
After switching off the engine,
slowly unscrew the tank cap.
Do not smoke while mixing petrol
or filling the tank. Immediately
wipe any spilled petrol off the
unit.
Before switching on the engine,

carry the unit at least 10 m away
from the filling station.
While filling the tank or using
the unit, do not smoke and keep
sparks and naked flames out
of the area.
Replace damaged exhausts,

fuel tanks, or filler caps.

Operating the unit

Never start the unit and never

leave it running in a closed
room or building. The inhalation
of exhaust gases may be fatal.
Use the unit outdoors only.
Wear eye and ear protection

when using the unit.
If working in a dusty environ-
ment, wear a face or dust mask.
A long-sleeved shirt is recom-
mended.
Wear thick, long trousers, boots

and gloves.
Do not wear loose clothing,
jewellery, short trousers, sandals
and do not walk barefoot.
Pin your hair above your shoul-
ders. If required, wear a hair net.
The cutting attachment cover

must always be attached when
you use the unit as a lawn
trimmer. Both trim lines must
be pulled out and the correct line
must be installed.
The trim line must not be pulled
out over the end of the cover.
The unit has a clutch.

The cutting attachment stops
when the unit is running at no
load. If it does not stop, have
the unit adjusted by a mechanic
at your authorised dealer.
Before switching on the unit,

ensure that line spool/cutting
blade cannot strike an object.
Adjust the handle bar to your

height so that the you have
the unit under control.
Operate the unit in daylight or

adequate artificial lighting only.
Avoid starting the unit uninten-

tionally. Be ready to operate
the unit when you pull the starter
rope. User and unit must be in
a stable position when the unit
is started. Follow the Start/Stop
instructions.
Use this unit for its designated

purpose only.
Do not stretch too far over

the unit. Always have a secure
footing and keep your balance.
When operating the unit, always

hold the unit firmly with both
hands. Always hold both sides
of the handle bar firmly.
When operating the unit, always

wear the shoulder belt.
Do not use the unit in adverse

weather conditions, e.g. if there
is a probability of rain or a storm.
Never change the engine

settings preset at the factory.
Keep away from naked flames,

avoid creating sparks and do not
smoke.
Never operate the unit with

a defective ignition switch.
Keep your hands, face and feet

away from all moving parts.
Do not touch the cutting attach-
ment while it is rotating and
do not attempt to stop it.
Do not touch the engine or

muffler. These parts become very
hot while the unit is being used.
They remain hot for a short time
even when the unit is switched
off.
Do not let the engine run quicker

than required for cutting
or trimming of lawn edges.
Do not run the engine at high
speed when it is not cutting.
Always switch off the engine

if you cannot start cutting
immediately or if you are moving
from one place to another.
If unusual vibrations occur,

switch off the engine immedia-
tely. Check the unit for damage.
If the unit is damaged, contact
a specialist workshop.
If you strike or ensnare a foreign

object, immediately switch
off the engine and check whether
the unit has been damaged.
Never use the unit with loose
or damaged parts.
Before removing blockages

or performing other work on the
unit, switch off the engine and
remove the spark-plug terminal.
Stop and switch the engine off

before performing maintenance
or repairs or before changing
cutting attachments.
Also pull out the spark-plug
terminal.
Use only original spare parts

for repairs.
These parts can be purchased
from your authorised dealer.
Never use parts, accessories

or attachments which are not
authorised for this unit.
Otherwise, the user may be
seriously injured and the unit
damaged. In addition, your
warranty may be deemed null
and void.
Keep the unit clean and ensure

that there are no plants or other
objects caught between the
cutting attachment and guard.
To reduce the risk of fire, please

replace damaged mufflers and
spark extinguishers and remove
grass, leaves, excess lubricants
and layers of soot from the
engine and muffler.
Have all repairs carried out

by a specialist workshop only.
Working with the cutting
blade (depending on model)
Before operating the unit, please

read all safety instructions
carefully.
Always keep the handle bar

between the user and cutting
attachment.
Never cut material if the cutting

blade is 75 cm or higher above
ground level.
English
5