Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000276-001.book Page 19 Monday, July 31, 2017 1:42 PM
en
19
Starting and stopping the drill motor
Fig. 11
(figure 11).
To start the drill motor with clockwise rota-
tion, press the button with the "
" symbol.
The drill motor starts with the highest speed.
The last set speed is automatically stored
(Memory Function). To start the power tool
with the last set speed, press and hold the
button with the "
" symbol, and then
100
%
l
85
%
l
press the button with the "
" symbol.
75
%
l
60
%
l
50
%
To lower the speed, press the "
".
l
25
%
l
To increase the speed, press the "
" sym-
bol.
To stop the drill motor, press the "
"
symbol.
100
%
Do not stop the drill motor during the drilling
l
85
%
l
75
%
l
procedure.
60
%
l
50
%
l
To start the drill motor with counterclock-
25
%
l
wise rotation, press the button with the
"
" symbol. The drill motor will run as
long as the button is pressed.
When the power supply is disconnected
while the drill motor is running, a protective
Memory Function
circuit prevents automatic restarting of the
drill motor. To continue use, the drill motor
must be restarted.
In case of overload, the drill motor automati-
cally stops and must be restarted again.
This machine is equipped with a motion sen-
sor. Excessive movement will cause this sen-
sor to actuate, which shuts the motor off. To
continue use, the drill motor must be
restarted.
Publicidad
