Environmental Protection (Advice On Using The Machine In Ways That Respect The Environment); Optional Accessories On Request; Accessories Available For Particular Types Of Work) - EMAK CR 270 Serie Manual De Uso Y Manitenimiento

oil must be taken in a sealed container
t o yo u r l o c a l s e r v i ce ce n t r e fo r
reclamation. Do not throw it in the
rubbish bin or pour it down a drain, on
the ground or into the water system.
Transmission oil check and replacement
CAUTION - Periodically check that there
are no oil leaks.
As planned maintenance on page 32, replace
the transmission oil in an authorized Service
Center.
The oil must be SAE 90W/140.
The amount of oil required is 1.5 liters.
Grease application
The following par ts need to be greased
regularly:
1. The box supports (Fig. 20).
2. The 4 crawler rollers (Fig. 21).
CAUTION:
- Apply grease also on sliding and rough not
mentioned.
- Apply grease regularly using a grease gun.
Major servicing
It is advisable to have the machine inspected by
a specialist technician at an Authorised Service
Centre at the end of each season, if used
intensively, or every two years in the case of
normal use.
8. ENVIRONMENTAL PROTECTION
Environmental protection should be a priority
of considerable importance when using the
machine, for the benefit of both social cohesion
and the environment in which we live.
- Try not to cause any disturbance to the
surrounding area.
- Scrupulously comply with local regulations
and provisions for the disposal of waste
materials after mowing.
- Scrupulously comply with local regulations
and provisions for the disposal of oils, petrol,
batteries, filters, deteriorated parts or any
elements which have a strong impact on the
environment. This waste must not be
disposed of as normal waste, it must be
separated and taken to specified waste
disposal centres where the material will be
recycled.
Demolition and disposal
When the machine reaches the end of its
service life, do not dispose of it into the
environment; instead take it to a waste disposal
centre.
Most materials used in the manufacture of the
machine are recyclable; all metals (steel,
aluminium, brass) can be delivered to a normal
recycling station. For information contact your
local waste recycling service. Waste disposal
must be carried out with respect for the
environment, avoiding soil, air and water
pollution.
In all cases, applicable local legislation must
be complied with.
9. OPTIONAL ACCESSORIES ON
REQUEST
Sideboards raising kit (Fig. 22)
Conversion Kit to increase the height of the box
sideboards, facilitating the transport of bulky
loads.
I
GB
F
D
E
NL
P
H
SK
CZ
RUS
UK
PL
FIN
BIH
SRB
HR
33