Structure Of The Io-Link Interface Data; Process Data - Aventics AV03/05 mit IO-Link Descripción De Sistema

6

Structure of the IO-Link Interface Data

6.1

Process data

Incorrect data assignment!
Danger caused by uncontrolled movement of the system.
Always set the unused bits to the value "0".
The IO-Link interface receives output data from the controller with set points for the position of the
valve solenoid coils. The multipole board translates this data into the voltage required to actuate the
valves. The multipole board of the IO-Link interface consists of six valve positions for double solenoid
valves. Single or double solenoid valve multipole extension kits can be added up to a length of 24
solenoid coils.
The exact assignment of the solenoid coils to the output bits depends on the type of valves used.
The different assignment tables for the possible configurations can be found in the appendix
(see "13.2 Address assignment table" on page 33).
AVENTICS | AV03/05 with IO-Link | R412018145–BAL–001–AC
WARNING
Structure of the IO-Link Interface Data
53