Secure Router 2330 Internal Module Installation And Removal; Removing The Secure Router 2330 Top Cover - Avaya 2330 Manual Del Usario

English

Secure Router 2330 internal module installation and removal

This section provides information for installing and removing Secure Router 2330 internal
modules.

Removing the Secure Router 2330 top cover

Use the instructions in this procedure to remove the Secure Router 2330 top cover.
Voltage:
Do not open the Secure Router 2330 top cover while the unit is powered.
Prerequisites
• Ensure you have a module ready to install before opening the chassis top cover.
• Ensure you have a Phillips #1 screwdriver.
• Ensure the Secure Router 2330 is powered off. You cannot hot swap internal
components.
1. Remove the three screws securing the left-hand side mounting bracket to the
2. Remove the three screws securing the left-hand side of the top cover to the
3. Remove the three screws securing the right-hand side bracket to the chassis and
4. Remove the three screws securing the right-hand side of the top cover to the
5. Slowly slide the top cover back to take it off of the Secure Router 2330.
24 Regulatory Information
chassis and the top cover.
See the following figure for reference.
chassis.
the top cover.
chassis.
Comments? infodev@avaya.com
August 2013