Installing The Secure Router 4134 Internal Pvm - Avaya 2330 Manual Del Usario

2. Remove the two screws that secure the VPN/IPSec module to the Main Board (see
3. Grasping the edges of the VPN/IPSec module, pull the module up and out of the
4. If you are not installing a VPN/IPSec module at this time, replace the service access

Installing the Secure Router 4134 internal PVM

Use the procedure in this section to install an internal PVM.
Prerequisites
• Ensure the Secure Router 4134 has the power switched off. You cannot hot swap internal
components.
• Ensure you have a PVM ready to install before opening the service access panel.
• Ensure you have a Phillips #2 screwdriver.
Regulatory Information
Voltage:
Do not open the Secure Router 4134 service access panel while the unit is
powered.
the following figure).
slot in which it is seated.
panel.
Secure Router 2330/4134 modules
August 2013 31