Removing The Secure Router 4134 Internal Vpn/Ipsec Module - Avaya 2330 Manual Del Usario

English
4. Using a Phillips screwdriver, tighten the two screws that secure the module to the

Removing the Secure Router 4134 internal VPN/IPSec module

Use the procedure in this section to remove a VPN/IPSec module from the Secure Router
4134.
Caution:
The internal VPN/IPSec module is not hot swappable. Do not open the Secure Router 4134
service access panel while the unit is powered.
Prerequisites
• Ensure you have a Phillips #2 screwdriver.
• Ensure the Secure Router 4134 has the power switched off. You cannot hot swap internal
components.
• Ensure you have an antistatic bag or sheet available for the VPN/IPSec that you are
removing.
Procedure steps
1. Remove the Secure Router 4134 service access panel. See Removing the Secure
30 Regulatory Information
Main Board.
Router 4134 service access panel.
Comments? infodev@avaya.com
August 2013