Installing The Secure Router 4134 Internal Vpn/Ipsec Module - Avaya 2330 Manual Del Usario

2. Slowly slide the access panel toward you until it is clear of the Secure Router

Installing the Secure Router 4134 internal VPN/IPSec module

Use the procedure in this section to install an internal VPN/IPSec module.
Prerequisites
• Ensure you have a VPN/IPSec module ready to install before opening the service access
panel.
• Ensure you have a Phillips #2 screwdriver.
• Ensure the Secure Router 4134 has the power switched off.
Procedure steps
1. Remove the Secure Router 4134 service access panel. See Removing the Secure
2. Locate the internal VPN/IPSec module connector slot.
3. Holding the VPN/IPSec module by its edges, align the connector with the slot on
Regulatory Information
4134.
Router 4134 service access panel.
Voltage:
Do not open the Secure Router 4134 service access panel while the unit is
powered.
the Main Board, pushing down gently, but firmly, to seat the module. The following
figure shows the location for installing the VPN/IPSec module.
Secure Router 2330/4134 modules
August 2013 29