ELICA ESR430S1 Guía De Instalación, Uso Y Mantenimiento página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7
Insert the two blower springs to the top of the range hood
housing, secure it with the four mounting screws previously
released,
8
onnect the blower harness to the hood.
C
Cabinet Installation
NOTE: Your cabinet must be able to support at least 88 lb (40kg).
1
Drive a mounting screw (from the hardware package)
partway into each center of the narrow neck of the keyhole
slots marked on the cabinet bottom.
2
Install the 4 - 4 x 8 mm mounting screws. Leave a
gap between the wall and the back of the screw head to
slide range hood into place
3
Fix the wiring conduit of the hood.
4
Slide the hood back against the cabinet. Tighten the
mounting screws. Be sure the screw heads are in the narrow
neck of the keyhole slot.
5
Drive 2 pieces of the selected screws in the security holes
(See the image below).
A
A. 4- 4x8 mm mounting screws
B. Round washers
C. Security screws
Wall Installation
Install framing for hood support
1
Mark the screw hole locations indicated in the "Outside
rear exhaust" figure.
2
If drywall is present, cut away enough drywall to expose
2 vertical studs at the indicated holes location. Install two
horizontal supports between two wall studs at the bottom
and upper mounting holes installation location.
3
The horizontal support must be flush with the room side
of the studs. Use cleats behind both sides of the support
to secure wall studs.
8
" (6.4 mm)
1
4
" (6.4 mm).
1
4
B
C
4
Reinstall drywall and refinish.
IMPORTANT: Framing must be capable
Centerline of
Installation
Space
5
Cut holes at marked locations for duct and electrical
wiring.
Mounting the hood
1
Drive a mounting screw (from the hardware package)
partway into each center of the narrow neck of the keyhole
slots marked on the wall's support frame.
2
Install the 2 pieces of the selected screws on the mountings
screws location (see the image). Leave a
between the wall and the back of the screw head to slide
range hood into place.
"
1
4
(6.4 mm)
3
Fix the wiring conduit of the hood.
4
Slide the hood back against the wall. Tighten the mounting
screws. Be sure the screw heads are in the narrow neck of
the keyhole slot.
B
C
A. Mounting screws
B. Upper security screws (Wall Installation)
C. Lower security screws (Wall Installation)
of supporting 100 lbs.
View from rear
Cleats
Mounting
Support
" (6.4 mm) gap
1
4
A
B

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Esr436s1

Tabla de contenido