Electrical Connection; Complete The Installation; Description Of The Hood; Control - ELICA ESR430S1 Guía De Instalación, Uso Y Mantenimiento

5
Drive 2 pieces of the selected screws in the upper security
screws location (see the image above).
6 Drive 2 pieces of the selected screws in the lower security
screws location (see the image above).
7 Connect Ductwork to hood.

Electrical connection

I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
DISCONNECT POWER BEFORE SERVICING.
REPLACE ALL PARTS AND PANELS BEFORE OPERATING.
FAILURE TO DO SO CAN RESULT IN DEATH OR ELECTRICAL
SHOCK.
• Remove the knockout and the Junction box cover and
install the conduit connector (cULus listed) in junction box.
A
B
C
D
A. White wires
B. Black wires
C. UL listed wire connector
• Run 3 wires; black, white and green ,according to the
National Electrical Code and local codes and ordinances,
in 1 ⁄ " conduit from service panel to junction box.
2
I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
ELECTRICALLY GROUND BLOWER.
CONNECT GROUND WIRE TO GREEN AND YELLOW GROUND
WIRE IN TERMINAL BOX. FAILURE TO DO SO CAN RESULT IN
DEATH OR ELECTRICAL SHOCK.
• Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
• Close and secure junction box cover.
Complete installation
Replace filters.
Check operation of the hood.
If range hood does not operate:
• Check that the circuit breaker is not tripped or the house
fuse blown.
• Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood, read
the "Maintenance" section.
Keep your Installation Instructions and Use and Care Guide
close to range hood for easy reference.
E
F
D. Green (or bare) and yellow-green
ground wire
E. Home power supply cable
F. UL listed or CSA approved ½" strain relief

Description of the hood

1
2
3
1.
Blower and light controls
2.
LED lamps
3. Grease filter handle
4. Grease filter

Control

The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the
hood before cooking and allow it to operate several minutes
after the cooking is complete to clear all smoke and odors
from the kitchen.
Fan Low / OFF / Hi
LIGHT Control switch
• Set light switch to ON or OFF.
FAN Control switch
• Set fan switch to OFF, LOW or HI speed as needed.
Always use the high setting when grilling.
4
Ligth ON / OFF
9