Brinly PCT-17BH Manual Del Proprietário página 10

================================================================================================
Assembly Step 5
Install Lock Bracket
Hardware Panel 3
1. Position the Lock
Bracket (12) over the
bed, as shown.
2. Secure the bracket (12)
from inside the cart bed (17) with
one 5/16 x 1 1/4" Round Head Screw (26),
and 5/16" Flat washer (6).
From the outside, add another 5/16" Flat Washer (6),
one 5/16" Lock Washer (5) and one 5/16" Hex Nut (4), as
shown. Assemble finger tight until all screws are installed.
3. Do NOT tighten nuts.
Assembly Step 6
Install Clevis
Hardware Panel 4
1. Position clevis (7) on the
cart drawbar (18) as illustrated.
2. Slide two 5/16 x 3/4 in. hex head bolts (2)
through the clevis (7) and the drawbar (18).
Secure beneath the drawbar (18) with two
5/16 in. nuts (22).
3. Install the clevis pin (13) through clevis and cart drawbar.
Secure with 1/8 in. hairpin cotter (25).
English Manual
ASSEMBLY
2
7
22
10
18
13
25
4
5
6
6
26
x2
2
22
x2
L-1821-H