Assembly - Brinly PCT-17BH Manual Del Proprietário

================================================================================================
Assembly Step 1
Install Supports
Hardware Panel 1
1. Position the Longitudinal
Supports (24) over the
bed, as shown.
2. Secure each support
from inside the cart bed (17)
with one 5/16 x 1 1/4" Round Head
Screw (26), and 5/16" Flat Washer (6).
From the outside, add another 5/16" Flat Washer (6),
one 5/16" Lock Washer (5) and one 5/16" Hex Nut (4), as
shown. Assemble finger tight until all screws are installed.
3. Do NOT tighten nuts (yet).
Assembly Step 2
Install Axle Support
Hardware Panel 2
1. Position the Axle Support (11)
over slotted holes over the
Longitudinal Supports (24) and
bed (17).
2. Secure in place from inside the
cart bed (17) with one 5/16 x 1 1/4" Round
Head Screw (26), and 5/16" Flat Washer (6).
From the outside, add another 5/16" Flat Washer
(6), one 5/16" Lock Washer (5) and one 5/16" Hex
Nut (4), as shown. Assemble finger tight until all
screws are installed.
3. Do NOT tighten nuts (yet).
English Manual

ASSEMBLY

24
7
4
5
6
6
26
x2
4
5
6
6
26
x8
L-1821-H