Brinly PCT-17BH Manual Del Proprietário página 8

================================================================================================
Assembly Step 3
1. Align the cart foot pedal (8) through slot in drawbar (18)
with the notch in the foot pedal oriented towards the raised
tongue on the drawbar. See illustration.
2. While holding the foot pedal (8) in place, flip the drawbar
(18) over.
Assembly Step 4-A
Squeeze in the latch spring (9) arms and slide in place, as
illustrated. ALIGNMENT NOTES:
• The widest portion of the spring will straddle the
larger of the two drawbar (18) openings.
• The loop of the spring is slightly raised away from the
drawbar and aligns with base of the foot pedal (8).
• Narrow end of the spring rests against the drawbar (18).
Assembly Step 4-B
Hardware Panel 3
Begin to slide the 3/8 x 3-3/4 in. bolt (3)
through the drawbar (18).
Between the drawbar and the latch spring (9),
add one 3/8 in. keps nut (10) to the bolt (3) as illustrated.
NOTE: Foot pedal can be adjusted slightly while installing
bolt (3). This will help to align the bolt with the hole on the
other side of the drawbar.
STARRED EDGE OF THE WASHER NEEDS TO BE FACING THE SPRING.
English Manual
ASSEMBLY
18
18
18
8
8
9
8
9
8
10
3
10
L-1821-H