Brinly PCT-17BH Manual Del Proprietário página 9

================================================================================================
Assembly Step 4-C
Hardware Panel 3
Continue to run the bolt (3) through
the latch spring (9), and foot pedal (8).
Between the latch spring (9) and drawbar, add one
3/8 in. keps nut (10) to the bolt (3) as illustrated. Finally, run the
end of the bolt (3) through the other side of the drawbar (18).
NOTE: Foot pedal can be adjusted slightly while installing bolt (3). This will
help to align the bolt with the hole on the other side of the drawbar.
STARRED EDGE OF THE WASHER NEEDS TO BE FACING THE SPRING.
Assembly Step 4-D
Hardware Panel 3
1. On the outside of the drawbar, add bolt (3) with a 3/8 in.
hex head locking nut (23) so that the foot pedal moves
forward and backward freely.
2. Tighten nuts (10) toward the spring, but allow movement.
Assembly Step 4-E
1. Pull the arms of the latch spring (9) up
and over the edges of the drawbar (18),
as shown.
English Manual
ASSEMBLY
18
9
9
10
8
3
10
10
3
10
23
18
L-1821-H