Test Process For All Parameters / Test Procedure - PrimeLab 1.0 Multitest Manual De Usuario

Test process for all parameters / test procedure

The steps up to the selection of the parameter to be determined (and the
associated test procedure) are the same for all procedures. Below are the steps
required to select the test procedure "11 chlorine tab" which is used as an example.
!
1 2
Accounts:
S m i t M i ,
M i l l P e , M u s t 1 , G
B a k e T h , T e s t 7 , B
1 2
Press button 3 and/or 2 to
select the account for which
the test is to be performed.
Confirm your selection by
pressing button 4.
The test results will then be
saved in this account.
Use the PrimeLab software
(Desktop Assistant) to store
up to 20 accounts on the
PrimeLab.
To do this, please refer to
the section "PrimeLab
Desktop Assistant".
TEST-7
Please always observe the important information and details for an
accurate measurement on pages "TEST-6" and "TEST-7".
Start screen:
Press button 1 to access
the menu "Test".
3 4
Test groups:
S a m p 5 , K
3 4 1
Press button 3 and/or 2 to
select the parameter group
containing the
parameter/method you
want to use for your test.
1 ) C e l l s , L i d s a n d
R o d s m u s t b e
c l e a n a n d f r e e
o f s c r a t c h e s
1
Alkalinity
Bromine
Chlorine
2 3 4
The safety notices pertaining to
achieving accurate
measurements are only
displayed after each new start-
up prior to your first
mesurement. Scroll down
using button 3 or skip with
button 4.
2 3 4
Tests:
11-Chlorine-Tab
12-Chlorine-Liq
14-Chlorine-HR-Tab
1 2 3
Press button 3 and/or 2 to
select the parameter / test
procedure to be used.
Confirm your selection by
pressing button 4.
All further steps are
described in the
instructions to the
individual test procedures.
Press button 2 in the test
result to repeat the
measurement without
going through the steps
again.
4
2
TEST-7