Install Bluetooth Usb Dongle - PrimeLab 1.0 Multitest Manual De Usuario

PrimeLab Desktop Assistant

Install Bluetooth USB dongle

If the computer on which you want to install the "PrimeLab Desktop
Assistant" is already fitted with Bluetooth connectivity please
UNDER NO CONDITION insert / install the Bluetooth USB dongle
!
This may lead to a situation where your system can not establish any
Bluetooth connection at all. Instead of using the Bluetooth USB dongle
supplied with PrimeLab you can use an existing Bluetooth installation in
your computer or any other Bluetooth adaptor to connect to PrimeLab!
Supplied free of charge
with every PrimeLab kit!
If after having carefully read and understood the above notice you want to install the
®
Bluetooth USB dongle supplied with your PrimeLab please follow the instructions
below.
1) Make sure that your computer is using any one of the following
operating systems: Windows 98, 98se, Me, 2000, XP, Vista, Windows 7
2) Insert the Bluetooth USB dongle supplied with your PrimeLab into
any empty USB slot of your computer. Check that the dongle is
completely pushed into position. The black end of the dongle will flash in
red.
3) Wait for the self-installation of the dongle. The installation progress is
displayed in intervals on the bottom right of the screen.
This can take several minutes!
Please wait for the following message:
"New hardware has been installed and can now be used!"
Only then continue with the next step:
"Connect PrimeLab with your PC".
If the installation fails remove the dongle from the slot, restart your system and
insert the USB dongle into a different USB slot, making sure that it is completely
pushed in, so that the installation can be restarted.
PDA-1
®
supplied together with your PrimeLab!
®
®
®
®
®
®
®
Bluetooth
USB dongle
®
PDA-1