Connecting Control Wires - ABB ACS55 Manual Del Usuario

18

Connecting control wires

Internal (1) or external (2) power supply can be used for the digital
inputs. Analogue control voltage is 0...10 VDC as default. (The AI
jumper must be in voltage ("U") position).
1)
2)
- +
12...24 VDC supply
Using 0/4...20 mA current signal:
- Change AI jumper to current
("I") position.
- Set AI OFFSET switch to ON
position if 4...20 mA current
signal is desired.
I
AI
U
1...10 kohm
COM
COM
SPEED/AI
+10V
+12V
I
START
AI
REV
JOG
U
SCR
Control terminals
• Conductor size: stranded 0.25...1.5 mm
• Tightening torque: 0.25 N·m.
# Name Description
1 COM Common for digital or analogue inputs
2 COM Common for digital or analogue input
3 AI Analogue input: Speed (frequency) reference.
0/2...10 VDC (Ri=190 kohm), or 0/4...20 mA
(Ri=100 ohm). Resolution 0.1%, accuracy +/-1%.
4 +10V Reference voltage for analogue input.
Accuracy +/-2%. Max. 10 mA.
5 +12V Auxiliary voltage for digital inputs. Max. 30 mA.
6 START Digital input 1: Start (resets the drive after a fault
2)
trip)
7 REV Digital input 2: Reverse rotation direction
8 JOG Digital input 3: Activate jog speed
9 SCR Earth for signal cable screen. Connected internally
to frame earth.
Relay output
1 RO1 Fault: Relay opens.12 V...250 VAC / 30 VDC
10 mA...2 A
2 RO2
1) Connected internally to frame (earth) through 1 Mohm resistor.
2) Digital input impedance is 1.5 kohm.
EN
2
(AWG 23 to AWG 16)
1)
1)
2)
2)