salmson Nexis-V x-care Instalación Y Instrucciones De Puesta En Marcha página 19

Designation Allocation
Earth connection
L, N Mains connection voltage
SSM Defect post relay
Earth connection for CAN bus
CAN L1 CAN Low
CAN L2 CAN Low
CAN H1 CAN High
CAN H2 CAN High
NOTE: CAN terminals (L1, L2, H1, H2 and Earth)
are compliant with "reinforced insulation"
(as described in EN61010-1) compare to main
(L, N) and SSM terminals (and vice-versa).
Connection to mains supply
Connect the 3 wire cables on the power terminals and
earth.
Connection of input / output
Connect CAN bus cables.
Use 2-wires shielded cable (0.2 to 2.5 mm
rigid).
Insulating diameter : 5 to 8 mm
Defect post relay connection.
Use 2-wires cable (0,2 to 2.5mm
Insulating diameter : 5 to 8mm
CAN bus DIP switch settings
CAN bus input cable only.
CAN bus (input / output).
- Screw X-Care cover.
SALMSON 12/2013
2 stranded or
2 stranded or rigid).
Notes
Single phase network
After several occurrences (up to 6 depending on fault
configuration) of one single defect, relay is disabled.
Dry-contact features :
minimum: 12 V DC, 10 mA
maximum: 250 V AC, 1 A
CAN bus input wire
CAN bus output wire
CAN bus input wire
CAN bus output wire
Terminals
L N
Terminals
CAN bus input wire
CAN bus output wire
Example: - One single product is connected
to CAN bus .
- Last device of a CAN network
(bus termination).
Example: Every devices of a CAN network
except termination.
English
19