Storing The Appliance; How To Use The Accessories - Kärcher SV 1802 Manual De Instrucciones

Storing the Appliance

Note:Always clean all the accessories that
you use and the water filter container (17)
before you put the machine away.
" Remove all accessories.
" Rinse all the accessories with clean wa-
ter and then let them dry.
Emptying and cleaning the water filter
container
" Lift the handle (18) of the water filter con-
tainer (Fig. 2) and remove the water filter
container (17) (Fig. 3).
" Turn the handle as shown in Fig. 4 and
remove the water filter unit (19).
" Empty the water filter container by tilting
it in the direction of the pouring device
(Fig. 10).
" Remove the pipe benders (23) from the
filter casing with the micro-perforation
grid (22) till it is fully detached (Fig. 11a).
" Remove all components and wash them
under flowing water. (Replace the filter if
it is damaged. Please contact an author-
ised Customer Service to procure a new
filter).
" Insert the water filter inlay (19) back into
the water container (17).
Caution!
Ensure that the arrow on the pipe bender
(23) matches the marking on the filter with
micro-perforation (22) (Fig. 11b).
" Roll the mains cable carefully and place
it in the cable casing (13) (Fig. 8).
" Place the water filter container (17) back
into its position and ensure that it is posi-
tioned correctly.
20
English

How to Use the Accessories

Please read the cleaning instructions of the
manufacturer before treating leather, special
fabrics and wooden surfaces and always do
a trial on a sample or some hidden part. Let
the steam-treated surface dry and then
check whether there are any changes to the
colour or form on account as reaction to the
steam.
We recommend that you be very careful
while cleaning wooden surfaces (furniture,
doors, etc.) because long exposure to steam
can damage the wax coating, the finish or
the surface colours. Hence we recommend
that you use steam only for short intervals or
first clean the surface with a cloth that has
been steam-moistened.
For highly sensitive surfaces (for e.g. syn-
thetic materials, painted surfaces, etc.) we
recommend that you use the steam function
at the minimum performance level.
Floor nozzle (D)
We recommend that you use the floor nozzle
on large surfaces, ceramic floors, marble
floors, parquet (only at maximum vacuum
cleaning level and minimum steam level),
carpets, etc. by using the following attach-
ments.
! Bursh lamellas (D1) for dry vacuum
cleaning.
! Hard rubber lamellas (D2) for cleaning
and brushing carpeted floors.
! Rubber lamellas (D3) for sucking in liq-
uids on smooth surfaces.
Mounting the attachments
" Remove existing attachments from the
side.
" Insert the desired attachments from the
side (Fig. C).
Hinweis:Push the brush lamella with crevic-
es in the front, the second one at the rear of
the nozzle.
While inserting rubber lamella (D3) make
sure that the smooth surface is on the inner
side.