Switching The Led Light On And Off; Soldering Iron Stand; Third Hand; Soldering Sponge - Parkside PLLL 16 A2 Traducción Del Manual De Instrucciones Original

Switching the LED light on and off
Switching on:
♦ Plug the mains plug
socket and press the On/Off switch
"ON" position.
Switching off:
♦ Set the On/Off switch
the illuminated magnifying glass
♦ Always remove the plug
when not in use.
♦ To protect the illuminated magnifying glass
fit the supplied magnifier cover
NOTE
► Avoid touching the magnifying glass with
your fingernails or other sharp objects.

Soldering iron stand

NOTE
► During breaks in work, the soldering iron
must be placed in the soldering iron stand
► Use only the soldering iron stand or another
fireproof surface when putting down the
soldering iron.

Third hand

CAUTION! RISK OF BURNS!
► The crocodile clips
during use.
♦ Fold the third hand
♦ Turn the crocodile clips
tion.
♦ Clamp the workpiece between the two crocodile
clips.
PLLL 16 A2
into an appropriate wall
to the
to "OFF" to turn off
.
from the socket
,
.
can get very hot
upwards.
in the desired direc-

Soldering sponge

CAUTION!
► The hot soldering tip
contact with a dry soldering sponge
Otherwise, the soldering sponge can be
damaged.
NOTE
► The soldering sponge is used to clean the
soldering tip.
► Dampen the soldering sponge before use.

Fitting the spindle roll

♦ Select the correct diameter of spindle roll
for the solder roll that you are using.
♦ Place the spindle roll on the solder coil mount
and guide the solder wire through one of the
three holes in the solder guide
.
must never come into
.
.
GB │ MT │
39 ■