Adjusting The Level Of The Appliance; Water Connection; Water Inlet Hose - Electrolux FAVORIT OPTIMAAA Manual De Instrucciones

2. Pull the worktop from the behind the ap-
pliance.
3. Lift the worktop and move it from the
front slots.
4. Use the adjustable feet to adjust the level
of the appliance.
Install the appliance under the kitchen work-
top. Make sure that there are no kinks in the
water hoses and that the water hoses are not
squashed.
If a repair is necessary, the appliance must be easily accessible for the engineer. Install the
appliance worktop to the appliance if you want to use the dishwasher as a freestanding
appliance.
The plinth on freestanding appliance is not adjustable.

Adjusting the level of the appliance

Make sure that the appliance is level to close and seal the door correctly. If the level of the
appliance is correct, the door does not catch on the sides of the cabinet. If the door does
not close correctly, loosen or tighten the adjustable feet until the appliance is level.

Water connection

Water inlet hose

Connected the appliance to a hot (max. 60°) or cold water supply.
If the hot water comes from alternative sources of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and aeolian), use a hot water supply to decrease
energy consumption.
Connect the inlet hose to a water tap with an external thread of 3/4".
CAUTION!
Do not use connection hoses from an old appliance.
The water pressure must be in the limits (refer to 'Technical data'). Make sure that the local
water authority gives you the average mains pressure in your area.
Make sure that there are no kinks in the water inlet hose and that the water inlet hose is
not squashed or entangled.
Fit the locknut correctly to prevent water leaks.
CAUTION!
Do not connect the appliance to new pipes or pipes that are not used for a long time. Let
the water run for some minutes, then connect the inlet hose.
Water connection
23