24
Water connection
The water inlet hose is double-walled and has an inner mains cable and a safety valve. The
water inlet hose is under pressure only while the water is running. If there is a leak in the
water inlet hose, , the safety valve interrupts the running water.
Be careful when you connect the water inlet hose:
• Do not put the water inlet hose or the safety valve in water.
• If the water inlet hose or the safety valve is damaged, immediately disconnect the mains
plug from the mains socket.
• Only let the Service Force Centre replace the water inlet hose with safety valve.
WARNING!
Dangerous voltage
Water drain hose
1. Connect the water drain hose to the sink spigot and attach it under the work surface.
This prevents that the waste water from the sink goes back into the appliance.
2. Connect the water drain hose to a stand pipe with vent-hole (minimum internal di-
ameter 4 cm).
Make sure that the drain hose is not bent or
squashed to prevent that the water drains does
not drain correctly.
Remove the sink plug when the appliance drains
the water to prevent that the water goes back into
the appliance.
A drain hose extension must not be longer than 2
m. The internal diameter must not be smaller than
the diameter of the hose.
If you connect the water drain hose to a trap spi-
got under the sink, remove the plastic membrane
(A). If you do not remove the membrane, remain-
ing food can cause a blockage in the drain hose
spigot
The appliance has a security feature to prevent
that dirty water goes back into the appliance. If,
the spigot of the sink has a 'non-return valve', this
valve can cause the appliance to drain incorrectly.
Remove the non-return valve.
max 85 cm
min 40 cm