Manufacturer's Genuine Repla- Cement Blades Bearing The Symbol - EMAK EF102C/15,5H Manual Del Usuario

EN 42
Sharpen the two cutting edges using a
medium grade grinding wheel and check
the balance by holding the blade up with a
round 18 mm Ø bar inserted in the central
hole.
WARNING!
!
blades must always be replaced;
never try to repair them! ALWAYS USE
MANUFACTURER'S GENUINE REPLA-
CEMENT BLADES BEARING THE
SYMBOL !
WARNING!
!
tra-rotating. When installing them, make sure that they are correctly posi-
tioned by refering to the code number marked on the outside of each one.
WARNING!
!
the indicated sequence, making
sure that the blades' wings are
facing towards the interior of the
cutting deck and that the cupped
side of the cup washer (1) is pres-
sing against the blade. Fully tigh-
ten the fixing screws (2), prefera-
bly using a torque wrench set at
45-50 Nm. If the shaft hub (3)
came off when dismantling the
blade, make sure that the key (4)
is firmly in its correct position.
6.3.2 C
UTTING DECK ALIGNMENT
The cutting deck should be properly set to obtain a good cut.
NOTE
always be 5 - 6 mm lower than the rear.
– Put the machine onto a flat surface and check the tyre pressures;
Damaged or bent
The blades differ, are at 90° to one another, and are con-
When re-fitting the blades, always follow
For achieving good results from cutting, the front part should
2
1
➤
With square profile cutting deck (☛ 2.2):
Mod. 102 © 82004341/1
➤
With round profile cutting deck (☛ 2.2):
Mod. 102 © 82004348/0
Mod. 122 © 82004350/0
MAINTENANCE
Ø 18 mm
4
1
2
1
2
82004340/1
82004347/0
82004349/0
3