EMAK EF102C/15,5H Manual Del Usuario página 64

EN 10
Line up the hole in the steering wheel hub with the hole in the shaft and insert the
pin supplied (3) using a hammer, ensuring that the end comes completely through
to the opposite side.
NOTE
screw-driver of the same size as the pin when hammering it in the last part
3.3 FITTING THE SEAT
Raise the adjustment lever (3) and fit the
seat (1) in the slide (2), introducing it from
the steering wheel's side, till the seat
engages in one of the 6 positions.
At this point the seat is engaged and can-
not be completely removed unless the
lever (4) is pressed, freeing it from its
retainer
WARNING!
!
switch socket (5) to the one coming
from the general wiring (6) to ensure
that the safety device works.
3.4 CONNECTING THE BATTERY
The battery (1) is situated under the seat
and is held in place by a spring (2).
Connect the red cable (3) to the positive
terminal (+) and the black cable (4) to the
negative terminal (–) using the supplied
screws and following the illustrated
sequence.
To avoid damaging the steering wheel, use a punch or a
Connect the micro-
UNPACKING AND ASSEMBLY
4
6
4
1
2 1 3
5
2
3