EMAK EF102C/15,5H Manual Del Usuario página 69

CONTROLS AND INSTRUMENTS
following symbols:
«CHOKE»
«SLOW»
«FAST»
– The «CHOKE» position (
mixture so must only be used for the time necessary when starting from cold.
– When moving from one area to another, put the lever in a position between
«SLOW» and «FAST».
– When cutting, go to the «FAST» position.
4.4 K
EY IGNITION SWITCH
This key operated control has three positions:
«OFF»
«ON»
«START»
On being released at the «START» position, the key will automatically return to
«ON».
4.5 P
ARKING BRAKE LEVER
This lever is to stop the machine from moving when it has been parked. There
are two positions:
«A» = Brake off
«B» = Brake engaged
– The brake is engaged by fully pressing the pedal (4.21 or 4.31) and moving the
lever to position «B». When you take your foot off the pedal it will be blocked
by the lever in the down position.
– A pilot lamp will warn that the brake is engaged (4.7.b).
– To disengage the parking brake, press the pedal (4.21 or 4.31). The lever will
return to position «A».
➤
( if fitted) for starting from cold
for minimum engine speed
for maximum engine speed
➤
if fitted instead of the 4.2 control) enriches the
everything is switched off;
activates all parts;
engages the starter motor.
EN 15