EMAK EF102C/15,5H Manual Del Usuario página 82

EN 28
from damaging the lawn if the ground is uneven.
The higher position excludes this possibility.
To change the position:
➤
with the round profile cutting deck ( ☛ 2.2),
unscrew and remove the pin (1) then reposi-
tion the wheel (2) in the upper and lower hole
of the wale corresponding to the wheel diame-
ter;
➤
with the square profile cutting deck
( ☛ 2.2), release the spring (3) with a screwdri-
ver to remove the pin and reposition the wheel
(4) as desired.
WARNING!
!
ENGINE OFF AND THE BLADES DISENGAGED.
To start cutting:
– put the accelerator into the «FAST» position;
– bring the cutting deck to the highest position;
– engage the blades (☛ 4.9);
– start moving forwards onto the grass area very gradually and with particular
caution, as already described;
– adjust the forward speed and the cutting height (☛ 4.10) according to the lawn
condition (height, density and dampness of the grass). On flat ground, these
general conditions can be followed
High and dense grass - wet lawn
Average condition grass
Low grass - dry lawn
➤
For hydrostatic drive models:
The speed is controlled in a gradual and progressive way by the pressure on
the drive pedal.
WARNING!
!
This work is to be done to all four wheels, WITH THE
When cutting on sloping ground, the forward speed
HOW TO USE THE MACHINE
1
3
2,5 km/h
4 ... 6 km/h
over 6 km/h
Ø 100
Ø 80
2
4