EMAK EF102C/15,5H Manual Del Usuario página 73

CONTROLS AND INSTRUMENTS
forward and reverse speeds.
– To engage forward drive just
press it in the «F» direction with
your toe-cap, noting that increa-
sing the pressure on the pedal
progressively increases the
speed of the machine
– Reverse is engaged by pressing
the pedal with the heel, in the
«R» direction.
– The pedal automatically goes
into neutral «N» when released.
– The neutral condition «N» is
shown by the lighting of a pilot
lamp (4.7.h).
WARNING!
!
only be engaged when the
machine is stopped.
NOTE
when the parking brake (4.5) is engaged, the engine stops. .
4.33 L
EVER TO RELEASE THE HYDROSTATIC TRANSMISSION
This lever has two positions as shown on the label:
«A» = Transmission engaged: for all usage conditions, when moving and
during cutting;
«B» = Transmission released: considerably reduces the effort required for
moving the machine by hand, with the engine turned off.
Reverse must
If the drive pedal is used, whether forwards or for reverse,
EN 19
4.31
4.32
N
F
R
4.33
A
B